L3447 Emax DC6/108L3728Doc. No.Model Apparatus ScalePage No.1SDH000635R00022b12a3456789101.5 Fixed part construction characteristicsFig. 4Fig. 5 Fig. 62. Checking on receiptExamine the state of the material received and its consistency with the content of the order. Should any damage or errors be found on unpacking,which must be carried out carefully, make the relative notification within and not over 5 days from the receipt of the material. The notification mustindicate the number of the shipping note.3. Storage, lifting and weightsThe circuit-breaker, protected by an external wooden crate, is fixed by means of screws to the transport pallet or to the bottom of the packingcase. If the circuit-breaker has to remain in the warehouse even for a short time before being put into service, after checking it on receipt, it mustbe put back in its container and covered with a waterproof sheet.Caution– Use a dry, dust-free room free of aggressive chemical agents as a storage room– Position the circuit-breaker and any fixed part on a horizontal surface, not in direct contact with the floor, but on a suitable support surface(Fig. 5)– The maximum number of stackable circuit-breakers is indicated in figure 6– Keep the circuit-breaker in the open position and with the closing springs unloaded to avoid unnecessary stresses and the risk of accidentsto the personnel.1 Steel sheet supporting structure2 Earthing contacts (a: for all versions; b: for E4,E6)3 Safety shutters (IP20 degree of protection)4 Insulating terminal support base5 Terminals6 Contacts for signalling connected/testisolated/disconnected (on request)7 Sliding contacts8 Padlock for safety shutters (on request))9 Anti-racking-in lock for circuit-breakers ofdifferent size10 Fixing holes (qty 4 for E2, E3, 6 for E4, E6)
