3.7.5 Reading the SIS output logsGeneralWhenever a set condition has expired (e.g. max allowed operation time beforeservice), a message to this effect will be shown in the Operational log.Access to logsHow to open a log and show its contents is detailed in the User's Guide, chapterService.Available messagesThe following messages may be shown:Meaning:SIS message in thelog:Available in:The manually set calendar time limit has expired.How to set the limit is detailed in section Settingthe SIS parameters on page 207.Service MessageService is due!X calendar dayssince last service.Calendar timeProceed with the required service as detailed inchapter Repair on page 211 or chapter Maintenanceon page 125 depending on which type of service.X number of calendar days remain until themanually set calendar time limit expires.Service MessageX calendar days tonext service.Calendar timeHow to set the value determining when the mes-sage is to be shown, is detailed in section Settingthe SIS parameters on page 207.The manually set operation time limit has expired.How to set the limit is detailed in section Settingthe SIS parameters on page 207.Service MessageService is due!X production hourssince last service.Operation timeProceed with the required service as detailed inchapter Repair on page 211 or chapter Maintenanceon page 125 depending on which type of service.X number of operation hours remain until themanually set operation time limit expires.Service MessageX production hoursto next service.Operation timeHow to set the value determining when the mes-sage is to be shown, is detailed in section Settingthe SIS parameters on page 207.The automatically calculated gearbox time limithas expired.Service MessageGearbox x requiresservice!Gearbox timeProceed with the required service as detailed inchapter Repair on page 211 or chapter Maintenanceon page 125 depending on which type of service.X percent of gearbox hours remain until the auto-matically calculated gearbox time limit expires.Service MessageX% of the service in-terval has expired forgearbox x!Gearbox timeHow to set the value determining when the mes-sage is to be shown, is detailed in section Settingthe SIS parameters on page 207.208 Product manual - IRB 6650S3HAC020993-001 Revision: Z© Copyright 2004-2018 ABB. All rights reserved.3 Maintenance3.7.5 Reading the SIS output logs
