ABB RMBA-01 User Manual
                              | |
Contents
| 
RMBA-01 User’s manual 3-1Chapter 3 – InstallationWARNING! Follow the safety instructions given in thisguide and in the ACS 800 Hardware Manual.Mounting The RMBA-01 is to be inserted into the position markedSLOT 1 on the drive. The module is held in place withplastic retaining clips and two screws. The screws alsoprovide the earthing of the I/O cable shield connected tothe module, and interconnect the GND signals of themodule and the RMIO board.On installation of the module, the signal and powerconnection to the drive is automatically made through a38-pin connector.The module can alternatively be mounted on a DIN rail-mountable AIMA-01 I/O Module Adapter (not availableat the time of publication).Mounting procedure:1. Insert the module carefully into SLOT 1 on theRMIO board until the retaining clips lock the moduleinto position.2. Fasten the two screws (included) to the stand-offs.3. Set the bus termination switch of the module to therequired position.Note: Correct installation of the screws is essential forfulfilling the EMC requirements and for proper operationof the module.Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com |
Related manuals for ABB RMBA-01
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine