ABB RTAC-01 User Manual

Contents

ABB RTAC-01 User Manual Manual pdf 13 page image

RTAC-01 User’s manual 3-1Chapter 3 – InstallationWARNING! Follow the safety instructions given in thisguide and in the ACS 800 Hardware Manual.Mounting The RTAC-01 is to be inserted into the position markedSLOT 1 or SLOT 2 on the drive. The module is held inplace with plastic retaining clips and two screws. Thescrews also provide the earthing of the I/O cable shieldconnected to the module, and interconnect the GNDsignals of the module and the RMIO board.On installation of the module, the signal and powerconnection to the drive is automatically made through a38-pin connector.The module can alternatively be mounted on a DIN rail-mountable AIMA-01 I/O Module Adapter (not availableat the time of publication).Mounting procedure:1. Insert the module carefully into SLOT 1 or SLOT 2on the RMIO board until the retaining clips lock themodule into position.2. Fasten the two screws (included) to the stand-offs.Note: Correct installation of the screws is essential forfulfilling the EMC requirements and for proper operationof the module.