2TLC172139M0201, rev. B 5 www.abb.com/ljokabsafety2013-03-022 OverviewGeneral descriptionABB/Jokab Safety adaptor units are used to adapt conventional safety sensors where the safety relies on e.g. one-or two-channel static signals, OSSD outputs, or short circuit detection, to the dynamic safety circuit monitored by aVital safety module or Pluto safety-PLC.Tina 7A is used to adapt safety sensors with mechanical contacts to the dynamic safety circuit. Examples of suchsafety sensors are emergency stops and switches or light curtains and light beams with internal relay outputs. Theunit is also able to monitor short circuits and can therefore also adapt safety sensors with safety contact rails, orsafety mats with internal relay outputs, to the dynamic safety circuit.Tina 7A is intended for use inside electrical cabinets where it can be mounted on 35 mm DIN rails and connectioncables can be connected directly to screw terminal blocks on the unit. Tina 7A is also equipped with a LED forvisual status information of the safety sensor and the dynamic safety circuit.The Tina 7A adaptor unit is intended for use in safety circuits in accordance with EN 60204-1.Warning! In order to maintain the highest safety level and reduce the risk of electrical interference the unit must beinstalled within the same physical encapsulation as the safety device. The connection cables should be as short aspossible (max 150 mm).Safety regulationsWarning!Carefully read through this entire manual before using the device.The devices shall be installed by a trained electrician following the Safety regulations, standards and the Machinedirective.Failure to comply with instructions, operation that is not in accordance with the use prescribed in these instructions,improper installation or handling of the device can affect the safety of people and the plant.For installation and prescribed use of the product, the special notes in the instructions must be carefully observedand the technical standards relevant to the application must be considered.In case of failure to comply with the instructions or standards, especially when tampering with and/or modifying theproduct, any liability is excluded.