ABB VSN900 Commissioning Manual

ABB VSN900 Commissioning Manual Manual pdf 21 page image

Connecting to InternetNote: The gateway uses Ethernet connection, for which you need an IP address (DHCP orstatic). The gateway is by default set to DHCP and tries to acquire the IP address from theDHCP server on your local area network. For setting a static IP, see Setting a Static IPaddress.1. Connect the gateway to the Internet through a local area network. Use the standardEthernet cable and connect to the Eth0 port of the gateway.Note: ABB does not provide Internet service or the cables required to connect thegateway to the Internet.2. Check that Ethernet port LED indicator status is Green. If no activity is seen on the LED,check all the connections.Setting up wireless connection for the gateway setupNote: ABB recommends to use Chrome v.55 or later or Firefox v.50 or later.1. Once powered, the gateway automatically creates a wireless network (approximately60 seconds).2. Enable wireless connection on the device used for setting up the gateway (eg. tablet,smartphone or PC) and connect it to the Wi-Fi access point created by the gateway.• Set the name of the wireless network for establishing connection. Eg:ABB-XX-XX-XX-XX-XX-XX, where “X” = hexadecimal digit of the wireless MACaddress. You can find the MAC address on the “Communication Identification Label”placed on the side of the gateway. See also the sample screen from a tablet withAndroid operating system.3. Enter the product key (printed on the gateway) as access point password. Considerdash "-" also as a character in the password field.Note: You can also recover the product key from Aurora Vision® cloud or contact ABBsupport.4. Open the browser and enter the preset IP address 192.168.117.1 to access the gatewayconfiguration interface.Start-up 2112