ABB i-bus KNX AC/S 1.x.1 Series Product Manual

Contents

ABB i-bus KNX AC/S 1.x.1 Series Product Manual Manual pdf 40 page image

ABB i-bus ® KNXCommissioning40 2CDC508198D0211 Rev. A | AC/S 1.x.16.2 Commissioning overviewThe individual commissioning steps should be undertaken in the following recommended sequence:Commissioning steps Remark1. Installation of the ETS application See chapter 6.4, Software / application2. Installation of DCA See chapter 6.4, Software / application3. Configuration of the device addresses The configuration of the physical KNX address andthe IP configuration can also be undertaken withoutDCA installed.• Physical KNX address See chapter 6.3, Assignment of the physicaladdress• IP configuration See chapter 6.3.1, Network settings• BACnet device address See chapter 7.2.2.3, BACnet parameter page4. Device firmware update check Check whether an update is available for the devicesoftware. In general an update will provide newfunctions and rectify any bugs.See chapter 10.3, Software update5. Minimum parameterization of the device• Set device clock See chapter 7.2.2.5, Clock parameter page• Set users and passwords See chapter 7.2.2.4, WebUI - Users parameter page• Set encrypted access to the web userinterfaceSee chapter 7.2.3.7, SSL certificate parameter page6. Parameterization of the device For a description of the commissioning interface inDCA, see chapter 6.5, Device Configuration App(DCA)For a description of the application-specificautomation modules (ASM) as well as the generaldevice settings, see chapter 7For general notes and remarks, see chapter 12,Planning and applicationTable 11: Commissioning overviewThe parameters are downloaded to the device using the ETS function Download. See chapter 6.5.11,Download reaction.The device is then in operation and undertakes the functions parameterized. For information on theoperation of the web user interface, see chapter 9.2, Web user interface.If you have any problems, see chapter 10.4, Support.