ABB i-bus KNX Product Manual
Also see for i-bus KNX: Product manualProduct manualProduct manualProduct manualProduct manual
                                                                                                                                                                      | |
Contents
| 
ABB i-bus ® KNXCommissioningDGN/S 1.16.1 | 2CDC 507 114 D0201 993.3.1 Brief overview of the communication objectsFlagsCO No. Function NameData PointType(DPT)Length C R W T0 In operation General 1.002 1 bit x x1 Manual operation block/status General 1.003 1 bit x x x x2 Trigger DALI addressing General 1.003 1 bit x x3 Fault gateway supply voltage General 1.005 1 bit x x x4 Acknowledge faults General 1.015 1 bit x x5 Request status values General 1.017 1 bit x x6…9 EmptySwitch DALI output 1.001 1 bit x x10 Switch/status DALI output 1.001 1 bit x x x x11 Status switch DALI output 1.001 1 bit x x x12 Relative dimming DALI output 3.007 4 bit x xBrightness value DALI output 5.001 1 byte x x13 Brightness value/status DALI output 5.001 1 byte x x x x14 Status brightness value DALI output 5.001 1 byte x x x15 Status switch coded DALI output NON DPT 2 byte x x x16 Status brightness value coded DALI output NON DPT 2 byte x x x17 Fault lamp DALI output 1.005 1 bit x x x18 Fault ballast DALI output 1.005 1 bit x x x19 Fault DALI DALI output 1.005 1 bit x x x20 Coded faults DALI output 237.600 2 byte x x x21 Number of faults statistic DALI output NON DPT 4 byte x x x22 Number of faults DALI output 5.010 1 byte x x x23 Fault group/device DALI output 5.010 1 byte x x x24 Switch up next fault alarm DALI output 1.008 1 bit x x25 Diagnostics DALI output NON DPT 2 byte x x x26 Disable sending of fault alarm DALI output 1.003 1 bit x x27 Flexible time DALI output NON DPT 1 byte x x28 Detect ballasts DALI output 1.010 1 bit x xBurn-in lamps DALI output 1.010 1 bit x x29 Burn-in lamps/status DALI output 1.010 1 bit x x x x30 Remaining burn-in time (coded) DALI output NON DPT 3 byte x x x31 Emergency test trigger DALI output NON DPT 2 byte x x x32 Emergency test status DALI output NON DPT 2 byte x x x33 Emergency test result DALI output NON DPT 4 byte x x x34 Emergency test stop DALI output 1.010 1 bit x x x35 Slave emergency active/status DALI output 1.010 1 bit x x x x36 Autom. emergency test start Converter 1...64 1.010 1 bit x x x37…39 Empty |
Related manuals for ABB i-bus KNX
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine