User manual Version 1.5SW5001 Wireless Serial ServerCopyright © 2010 Atop Technologies, Inc.All rights reserved. Designed in Taiwan- 35 -Fig 50. Connected to AP from Site list6.3.4. Manual Wireless SettingsOperation: [Main] Æ [3 Wireless Setting] Æ [7 Manually Settings]User can manually configure SW5001 wireless configurations by enter 7 at the Wireless Settings page.Then user can set any wireless parameters by enter the menu corresponding to that parameters. Wirelessparameters are shown in Fig. 51 below.Fig 51. Configure Wireless LAN by Manual6.3.5. Configure Ad-Hoc ModeOperation: [Main] Æ [3 Wireless Setting] Æ [7 Manually Settings] Æ [2 Topology]Independent Basic Service Set (IBSS), the most basic type of IEEE 802.11 wireless LAN, is commonlyreferred to as an ad-hoc network. An IBSS may consist of as few as two stations. Unlike infrastructure mode,all stations are capable of communicating directly with each other without access point.User can configure Wireless SW5001 to be Ad-Hoc mode, by manually configure the wireless networktopology as shown in Fig.52 below.