ABON Ultra S Installation And Operating Instructions Manual
Also see for Ultra S: Operating instructionsInstallation and operating instructions
        | |
47EnglishBasic settings (learning ofend positions and forces)For performing basic settingsthe door drive must be coupled withthe door. During learning there is stillno protection by the safety switch-offdue to excess force.There are two learningpossibilities:• With transmitter [35]• Without transmitter [36-39]Learning with transmitterButton 1: Dead man operation and fine-tuning upButton 2: Dead man operation and fine-tuning downButton 3: Confirmation (save)Button 4: Confirmation (save)End position „UP“[35] Activate button 1 and keep itpushed, the door moves to open.At the moment, where the desiredend position „UP“ is reached, re-lease button 1.A correction of end position „UP“ ispossible by pushing button 2.Confirm reached end position„UP“ by short pushing of button3 or 4, the drive lamp flashes3 times. After learning end position„UP“, the door is run automaticallyin closing direction. The drive stopsautomatically, once the right closedposition is reached.Drive assembly[4-14] See installation scheme (imagepart).Adjusting tension of drivebelt[15-] Tighten safety nut (24), until thedrive belt (5) does not lie tight in-side the guide rail (10) and isslightly tightened.Installation[17-29] See installation scheme (imagepart).Support drive with suitable aidsafter lifting towards the ceiling andsecure against falling. Inspect mount-ings at ceiling and lintel again afterinstallation [23,24,29].Door connectionDepending on the door type, thereare different installation sets available.Connect door and drive according to theinstruction, enclosed in the installationset.If the door cannot be coupled withthe drive, the sled (4) has to be run inclosing direction by means of button 2 ofthe transmitter, or the sled has to be un-locked. Couple door for performing oflearning runs [35]. If the end positionhas been activated unintentionally, themains plug has to be unplugged for 2seconds (=reset).Control componentsControl and display elements [30]1 „Impulse“ button2 „Program“ button3 LED (red)4 LED „Power“ (green)External connections [30]5 Emergency stop6 Safety strip/optical sensor/light barrier(SE/LS)7 Impulse8 Antenna A = AntennaE = EarthingPutting door drive intooperationConnect antenna[31] Unpack hand-held transmitter andantenna.[32] Connect antenna (8) to externalterminal (8, right screw terminal A).Connect to mains power[33] Open door slowly by hand until thesled audibly snaps in.[34] Plug in mains plug. The LED „Pow-er“ (4) must light, the drive lampflashes 4 times.Make sure that no people, ani-mals or objects are in the range ofmovement of the door before activat-ing the drive. |
Related manuals for ABON Ultra S
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine