ACP RCS10DA Service

Contents

ACP RCS10DA Service Manual pdf 27 page image

Disassembly Procedures To avoid the risk of electrical shock, personal injury, or death,disconnect power to oven and discharge the capacitors beforefollowing any disassembly procedure.WARNING!27 16023293 Rev. 0 ©2010 ACP, Inc.Blower Motor or Wheel1. Disconnect power to oven and remove outer case,(see "Outer Case" procedure).2. Remove outer case.3. Disconnect wiring from blower motor.4. Remove screws securing scroll to chassis.5. Slide scroll discharge snout from partition and liftscroll assembly from unit.6. Replace component and reverse procedure toreassemble.Splatter ShieldNOTE: Be careful not to bend antenna when removingsplatter shield. Shield snaps into a lip in front ofthe oven and three slots in the back.1. Place your thumbs in the two indentations in front ofthe shield.2. Press lightly towards the back and carefully lowershield away from antenna.3. Pull shield out of the back slots and out of the oven.SplattershieldAntenna1. Remove splatter shield from oven cavity.2. Remove two mounting rivets on the top of oven cavityto remove cradle. Support cradle before removingmounting rivets to avoid damage to antennaassembly.Stirrer Motor1. Disconnect power to oven and remove outer case,(see "Outer Case" procedure).2. Remove outer case.3. Disconnect wire terminal s from stirrer motor.4. Remove screws securing stirrer motor to wave guide.5. Replace component and and reverse procedure toreassemble.NOTE: When replacing stirrer motor, verify motor shaft isaligned with antenna shaft before securing withscrews.