ACP RFS12MPSB Service Manual

ACP RFS12MPSB Service Manual Manual pdf 7 page image

Important Safety Information©2010 ACP, Inc. 16400007 Rev. 0 7Grounding InstructionsWARNING!Do not remove grounding prong when installinggrounded appliance in a home or business that doesnot have three wire grounding receptacle, under nocondition is grounding prong to be cut off or removed.It is the personal responsibility of the consumer tocontact a qualified electrician and have properlygrounded three prong wall receptacle installed inaccordance with appropriate electrical codes.WARNING!To avoid the risk of electrical shock or death, do notalter the plug.WARNING!To avoid the risk of electrical shock or death, thisequipment must be grounded.This equipment MUST be grounded. In the event of anelectrical short circuit, grounding reduces the risk ofelectric shock by providing an escape wire for theelectric current. This oven is equipped with a cordhaving a grounding wire with a grounding plug. The plugmust be plugged into an outlet that is properly installedand grounded.Consult a qualified electrician or servicer if groundinginstructions are not completely understood, or if doubtexists as to whether the equipment is properlygrounded.Do not use an extension cord. If the product power cordis too short, have a qualified electrician install an appropriatereceptacle. This oven should be plugged into aseparate 50 or 60 hertz circuit with the electrical rating asshown in the appropriate drawing. Models operate with a120 supply voltage. When an oven is on acircuit with other equipment, an increase in cookingtimes may be required and fuses can be blown.WARNING!To avoid risk of electrical shock, injury or death; makesure these grounding instructions are followed.• Do not operate or allow oven to be operated withdoor open.• Make the following safety checks on all ovens to beserviced before activating the magnetron or othermicrowave source, and make repairs as necessary:• Interlock operation• Proper door closing• Seal and sealing surfaces (arcing, wear, andother damage)• Damage to or loosening of hinges and latches• Evidence of dropping or abuse• Before turning on microwave power for any servicetest or inspection within the microwave generatingcompartments, check the magnetron, waveguide ortransmission line, and cavity for proper alignment,integrity, and connections.• Any failed or misadjusted components in theinterlock, monitor, door seal, and microwavegeneration and transmission systems shall berepaired, replaced or adjusted by proceduresdescribed in this manual before oven is released tothe consumer.• Check microwave leakage to verify compliancewith the federal performance standard should beperformed on each oven prior to release to theconsumer.PRECAUTIONS TO BEOBSERVED BEFORE ANDDURING SERVICING TOAVOID POSSIBLE EXPOSURETO EXCESSIVE MICROWAVEENERGY, OR ELECTRICALSHOCK. DISCONNECTPOWER TO OVEN.! WARNING!NEMA 5-20R/5-20P120V–20AMP