ACR Electronics Nauticast Y1-03-0212 Installation Manual

Also see for NAUTICAST 2662: User manual Manual Installation manual Manual Manual

Contents

ACR Electronics Nauticast Y1-03-0212 Installation Manual Manual pdf 18 page image

Installation Manual 14 Y1-03-0212 Rev. E3.8 Sensor Software Configuration3.8.1 IntroductionThe NAUTICAST AIS requires a connection to various sensor devices. Sensor Configurationshould enable compatibility with existing navigation devises aboard any vessel.This chapter deals with several ways to configure the NAUTICAST and to comply with therequirements of the specific sensor interfaces.Configuration and display is visible on two screens of the Sensor Configuration Menu. TheNAUTICAST offers the following configuration options:Set up data speed 4800/9600/38400 baud.Monitor the connected sensor inputs for each sensor channel.Verify and edit the Sensor Configuration on the display screen.Analyze the information received from the connected sensor devices.Produce an electronic installation report.Configuration of various NMEA protocols.The individual options may be repeated until the required configuration for the connectedsensor devices is achieved.During the configuration process, the NAUTICAST is not operational.3.8.2 Set up Sensor Speed, Checksum (CRC) and NMEA Talker and Sentence IDThe Sensor configuration is accessible via the submenu „5. Sensor Settings‟ in the ServicePassword protected menu: „5. Transponder Configuration‟. Please see the appendix in yourUser Manual for password information.N 1o19' E 0o13' |1> N/A|2>0.00|3>0.10nm|----------------------------------| 5. Transponder Configuration-----| || +- 1. Change User PasswordView | +- 2. Region Settings| +- 3. Alarm Settings-----| +- 4. Interrogation Settings| +- 5. Sensor SettingsMsg. ||-----||Displ|----------------------------------------NUM|Select->| | |<-Back