Installation Manual 32 Y1-03-0212 Rev. E4 Starting the NAUTICAST4.1 Initial Set Up of the NAUTICAST for operationATTENTION: AUTHORITIES MANADATE THAT YOU ENTER THIS INFORMATION.After installing the antennas and hardware the following User, Voyage related and ShipSettings data needs to be entered. Upon Start-up (Applying power) enter the followinginformation.a) Enter MMSI Number - See paragraph 4.2 on entering information.During the initial boot or after “factory settings” the user is asked to enter a valid MMSInumber. As long as this is not done, the system does not transmit. This appears asAlarm-ID 56 with the text “AIS: ENTER MMSI NUMBER”.b) Enter IMO Number, Designated Area Code (DAC) and European Ship Number (ESN)- See paragraph 4.2 on Entering information.c) Select AIS Mode – According to the local requirements you have to select the AISMode between Inland AIS or SOLAS AIS.See paragraph on altering this information.d) Ship Settings Data - After initial entry of the Ship Settings Data any changes in theinformation below should be edited accordingly. See Paragraph 4.3 on enteringinformation.Enter Call SignEnter Ships NameEnter Length of ShipEnter Beam of ShipEnter Internal GPS antenna PositionEnter External GPS Antenna Position (If Applicable).Enter Ship Typee) Voyage related Data – After initial entry of the Voyage related Data any changes inthe information below should be edited accordingly.See Paragraph 4.4 on entering information.Enter Cargo TypeEnter DraughtEnter DestinationEnter ETAEnter Navigation Status.f) Password – Service and User passwords see section 4.6 or see the appendix in yourUser Manual for password information.LAT: N/A SOG: N/A 00/00/00LON: N/A COG: N/A 24:60:60IntN/A: STOP ! 7A 1T++++++++++++++++++++++++++++++++++++++++Time 24:60 00/00[!] ALARM ID:56AIS: ENTER MMSI NUMBERPlease press OK to enter MMSI number!Tx temporary suppressed++++++++++++++++++++++++++++++++++++++++----------------------------------------| OK | | |