ACR Electronics THUNDERBIRD S.S.A.S. Product Support Manual

Also see for RLB-33S - REV D: Product support manual

Contents

ACR Electronics THUNDERBIRD S.S.A.S. Product Support Manual Manual pdf 28 page image

Y1-03-0180 Rev. A27INSTALLATION CHECK LISTPlease Review to ensure you have properly installed this SSAS beacon: Installed the beacon and bracket on a flat vertical surface in a discreet location. (Paragraph 3.2) Installed the activation switches. (Minimum of two.) One must be on the navigation bridge. Switches shall not be labeled. (Paragraph 3.3.4) Connected switch wire to switches and terminal block on the top of the mounting bracket. Routewire appropriately. (Paragraph 3.3.5) Assembled the antenna using the rods, set screws and wrench provided. (Paragraph 3.4.3) Installed the antenna in a location at least at least 10 ft (3 m) above deck and with clear view ofthe sky using either the included 4” mount or other mount with compatible 1” x 14 threads.(Paragraph 3.4.4) Connected antenna to beacon using SMA and TNC connectors provided and RG-8/U coaxialconnector. Route cable appropriately. (Paragraph 3.4.5) Upon completion of the installation, perform the Activation Switch (Paragraph 3.3.6) and CrossDipole Antenna (Paragraph 3.4.6) Installation Verification Tests. Upon successful completion of Installation Verification Tests, place the beacon in READY mode.ADDITIONAL NOTES:

/ 28

Related manuals for ACR Electronics RLB-33S - REV D