198 After printing, place the printout onto the mat, in the same orientation you see in the main window and insertthe mat into the ACS-24UHF. As you are facing the ACS-24UHF, the printout should be on the mat in aportrait orientation with the arrow pointing towards the right end cap:9.04 PNC Procedure Part 2: Aligning and CalibratingAligning the Laser with the Registration Marks Click on the Cut Project With icon to go to the cut window. If you haven’t yet performed a test cut, do sonow using either the Knife Point or WYSIWYG setting. Perform the test cut in a location that won’t be partof your final cut or use a scrap of the same material you are cutting. After the test cut is successful, move the laser light (or alignment pin) until it is directly over the lower rightcorner of the printout, as indicated in Section 9.03. Set the origin. Under Cut Type, select Print and Cut: Click on Start and the following window will open. Check Fixed Length and enter 11.0”, or whatever widthyou used when setting up your custom Virtual Mat. Then click on Begin. The laser (or alignment pin) should automatically move to within a very short distance of the first registrationmark. The following window will open:Set the origin in the bottomright corner of the printout,using the laserPlace your printouton the cutting mat inthis orientation.Feed the mat thisdirection into theACS-24UHFIMPORTANT: Set Us and Cut Speeds to 200
