www.acti.comHardware Manual21Step 2: Install the New Ethernet Cable1. Insert the new Ethernet cable through the sealing nut, claw, seal, and cablegland of the back cover.2. Attach the RJ-45 connector to the Ethernet cable. See How to Make anEthernet Cable on page 33 for more information.3. Assemble the seal and claw, and then connect the RJ-45 connector to theEthernet port inside the camera.4. Attach the back cover by tightening the three (3) screws.NOTE: Make sure the rubber ring on the cover is secured and the screws arecompletely tightened to avoid possible water leak.2212
