ADJ 1226100361 User Instructions

ADJ Products, LLC - www.adj.com - 12P Hex IP User Manual Page 1712P Hex IP Operating InstructionsDMX Addressing:Operating through a DMX controller gives the user the freedom to create their own programs tailoredto their own individual needs. The 18P Hex IP has 4 DMX modes: 6 Channel mode, 7 Channel mode,8 Channel mode, and a 13 Channel mode.1. To run your fixture in DMX mode press the MODE button and press the UP or DOWN buttonsuntil “Menu Set Addr” is displayed and press ENTER. The current DMX address will now bedisplayed. Use the UP or DOWN buttons to find your desired DMX address, and press ENTER .2. Please see page 12 for DMX values and traits.DMX Channel Mode - With this function, you can select your desired DMX channel mode.1. Access the main menu, and press the UP or DOWN buttons so that “Menu User Mode” is highlighted,then press ENTER.2. Press the UP or DOWN buttons to scroll through the 4 DMX channel modes. When you havefound your desired DMX channel mode, press ENTER.3. Press the MODE button to return to the main menu.Dimmer Mode Setting:1. Access the main menu, and press the UP or DOWN buttons so that “Menu Function” is highlighted,then press ENTER. Press the UP or DOWN buttons so that “Dim Mode” is highlighted.2. There are 5 dimmer mode settings to choose from. Please see the Dimmer Mode Chart on page22 to see the settings and their respective beginning and ending fade times.DMX State:This mode is used as a precaution mode, that in case the DMX signal is lost, the operating modechosen in the setup is the running mode the fixture will go into when the DMX signal is lost. You canalso set this as the operating mode you would like the unit to return to when power is applied.1. Access the main menu, and press the UP or DOWN buttons so that “Menu Function” is highlighted,then press ENTER. Press the UP or DOWN buttons so that “NODMX” is highlighted.2. Use the UP and DOWN buttons to scroll through the 3 DMX standing states.• “Hold” - If the DMX signal is lost or interrupted, the fixture will stay in the last DMX set up.If power is applied and this mode is set, the unit will automatically go into the last DMX set up.• “Blackout” - If the DMX signal is lost or interrupted, the unit will automatically go into standby mode.• “Program” - If the DMX signal is lost or interrupted, the unit will automatically go into Auto Runmode.3. Use the UP and DOWN buttons to find your desired DMX state and press ENTER to confirm andpress MODE to exit.Auto Run Mode:1. Access the main menu, and press the UP or DOWN buttons so that “Menu Function” is highlighted,then press ENTER. Use the UP or DOWN buttons to highlight “AUTO RUN FQN” and pressENTER.2. Use the UP or DOWN buttons to scroll through the 99 Auto Run programs. Press ENTER to confirmyour selection.