ADJ 1226100361 User Instructions

ADJ Products, LLC - www.adj.com - 12P Hex IP User Manual Page 20Time Information:1. Plug the fixture in and press the MODE button and press the UP or DOWN buttons until“Menu Info” is displayed, and press ENTER.2. Press the UP or DOWN buttons to scroll through the different information menus. Press ENTERto access your desired menu.3. Use the UP and DOWN buttons to scroll through time information menu.• “TimeInfo Current” - This will display the current running time of the fixture in hours.• “TimeInfo TotalTim” - This will display the total running time of the fixture in hours.“TimeInfo LastClea” - This will display the last time the running time was cleared.“TimeInfo TimerPIN” - This menu function will allow you to clear the running time.“TempInfo” - This will display the current running temperature“Model Inf” - This will display the model name.“ErrorInf” - This will display any error information.Secondary Setting - With this function you can set the unit as a “Secondary” in Primary-Secondaryconfiguration.1. Plug the fixture in and press the MODE button and press the UP or DOWN buttons until“Secondry” is displayed, and press ENTER.2. The unit is now set as a “Secondary” in a Primary-Secondary configuration.Manual Control - With this function you can manually adjust all colors to make your own desiredcolor.1. Plug the fixture in and press the MODE button and press the UP or DOWN buttons until“Menu Manual” is displayed, and press ENTER.2. Press the UP or DOWN buttons to scroll through dimmer, the 6 colors, and strobe. Press ENTERand use the UP and DOWN buttons to make adjustments.3. Once you have made your desired adjustments, press ENTER.12P Hex IP Operating Instructions12P Hex IP Primary-Secondary ConfigurationPrimary-Secondary Configuration:This function will allows you to link units together to run in a Primary-Secondary set-up.In aPrimary-Secondary set up one unit will act as the controlling unit and the others will react to thecontrolling units built-in programs. Any unit can act as a Primary or as a Secondaryhowever, onlyone unit can be programmed to act as the “Primary.”Primary-Secondary Connections and Settings:1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR datacables to link your units together. Remember that the Male XLR connector is the input and theFemale XLR connector is the output. The first unit in the chain (primary) will use the female XLRconnector only. The last unit in the chain will use the male XLR connector only.2. Connect the first “Secondary” unit to the “Primary.”3. Set the “Primary” unit to your desired mode of operation. On the “Primary” unit’s press theMODE button and use the UP or DOWN buttons until “Menu Secondry” is displayed andpress ENTER.