ADJ 6-PACK SKB CASE User Instructions

ADJ Products, LLC - www.adj.com - Element HexIP Pearl User Manual Page 10Element HexIP Pearl Layout Diagram1. Battery On/Off Switch: This switch is used to activate the batterypower. You must also activate the LOAD function. See page23 “Load Setting” to activate.2. Kickstand: This kickstand is used to angle the unit to variousdegrees. There are 3 different degree levels. Note: Be verycautious at the degree in which you angle the unit at, due tothe fact that it could fall over.3. Power Input & Fuse Holder: This input is used to connect theincluded I.E.C. power cord. After connecting the powercord, plug the other end into a matching power source.Located inside the power socket is the fuse housing. Seepage 36 for fuse replacement.4. Mode Button: This button lets you scroll through the system menu.Setup Button: This button lets you Enter submenu’s.Up & Down Button: These button’s are used to scroll throughsubmenu’s and make adjustments in the submenu’s5. Digital Display: This will display the various menu’s, submenu’s,and adjustments.6. Control Panel Access Door: Lifting this door will allow you toaccess the controls and functions.123456ADJ Products, LLC - www.adj.com - Element HexIP Pearl User Manual Page 29Element HexIP Pearl Operating InstructionsWiFly On/Off and Wireless Addressing:This function is used to activate the WiFly control and set the WiFlyaddress.NOTE: The address must match the address that is set to WiFlyTransCeiver or WiFly controller.1. Plug the fixture in and press the MODE button until “rCXX” isdisplayed. You are in wireless set up mode.2. Press the UP or DOWN buttons the UP or DOWN buttons to turnthe Wireless “On” or “Off”.3. Press the SET UP button to enter the Wireless address menu. Usethe UP or DOWN buttons to select your desired Wireless address.Activate IR Sensor:This function is used to activate and deactivate the IR sensor. Whenthis function is activated you can control the fixture using the UC IR orAirstream IR App. Please see page 31 for controls and functions.1. Plug the fixture in and press the MODE button until “dXX” is dis-played. “XX” represents either “on” or “oFF”.2. Press the SET UP button until “IrXX” is displayed. “XX” representseither “on” or “oF”.3. Press the UP or DOWN buttons to either activate the remote func-tion (On) or deactivate it (Off).Slave Setting:1. Plug the fixture in and press the MODE button until “SLAv” isdisplayed. The unit now designate a “Slave” unit in a Master-Slaveset up.Default Running Mode:This is a default running mode. When this mode is activated all modeswill return to their default settings.1. Plug the fixture in and press the MODE button until “dXX” is dis-played. “XX” represents either “on” or “oFF”.2. Press the SET UP button until “dEFA” is displayed.3. Press the UP and DOWN buttons simultaneously. Press theMODE button to exit.