ADJ Crazy Pocket 8 User Instructions

Contents

A.D.J. Supply Europe B.V. – www.americandj.eu – CRAZY POCKET 8 User Instructions Page 12OPERATION (continued)Show Mode: In this mode you can choose 1 of 4 show modes to run.1. Press the MENU button until “SHND” is displayed, and press ENTER.2. Press the UP or DOWN buttons until you find your desired show, and press ENTER then press and holdMENU for 3 seconds to confirm.MASTER-SLAVE CONFIGURATIONMaster-Slave Operation This function will allow you to link up to 16 units together and operate without acontroller. In a Master-Slave set up one unit will act as the controlling unit and the others will react to thecontrolling units programs. Any unit can act as a Master or as a Slave.1. Using approved DMX data cables, daisy chain your units together via the XLR connector on the rear of theunits. Remember the Male XLR connector is the input and the Female XLR connector is the output. The firstunit in the chain (master) will use the female XLR connector only - The last unit in the chain will use the maleXLR connector only. For longer cable runs we suggest a terminator at the last fixture.2. For the Master unit press the MENU button until “SLND” is displayed, and press ENTER. Set the unit to“MAST” and press ENTER.3. Next set the Master to your desired operating mode.4. For the slave units press the MENU button until “SLND” is displayed, and press ENTER. Set the slave unitsto either “SL 1” or “SL 2”.5. The slave units will now follow the Master unit.UC IR CONTROLThe UC IR (sold separately) infrared remote gives you control of various functions (See below). To controlthe fixture you must aim the remote at the front of the fixture and be no more than 30 feet away.The Crazy Pocket 8 comes with the Airstream IR remote transmitter. The transmitter plugs into theheadphone jack of your iOS phone or tablet. To control your IR fixture you must raise the volume to themaximum on your iOS phone or table and aim the transmitter at the front of the fixture and be no more than 15feet away. After you have purchased the Airstream IR transmitters, the app is a free download from the appstore for your iOS phone or tablet. The app comes with 3 pages of control depending on the IR fixture you areusing. Please see below for IR functions including the corresponding app page.Works with App page 1.STAND BY - Pressing this button will blackout the fixture.FULL ON - Hold this button down to fully light up the unit. When you let the button go, the unit will return to itsprevious state.FADE/GOBO - This button is invalid for this fixture.“DIMMER +” and “DIMMER -” - These buttons are used to adjust the output intensity.STROBE - Press and hold this button for random strobing. Press the button to activate sound active strobing.COLOR - Press this button and use buttons 1-4 to select either of the RGBW colors.1-9 - When in color or show mode these buttons will allow you to select your desired color or show. See Coloror Show for more info.SOUND ON & OFF - These buttons activate and deactivate the sound active mode.SHOW 0 - This activates the show mode. Press the Show 0 button to activate random show mode, or usebuttons 1-4 to select a preset show.