ADJ ENCORE PROFILE PRO COLOR User Instructions

7Encore Profile Pro Color Safety PrecautionsTHIS FIXTURE IS COMPOSED OF SOPHISTICATED ELECTRONIC COMPONENTS. TOGUARANTEE SMOOTH OPERATION, IT IS IMPORTANT TO FOLLOW ALL INSTRUCTIONS ANDGUIDELINES IN THIS MANUAL. ADJ PRODUCTS, LLC IS NOT RESPONSIBLE FOR INJURY AND/OR DAMAGES RESULTING FROM THE MISUSE OF THIS FIXTURE DUE TO THE DISREGARD OFTHE INFORMATION PRINTED IN THIS MANUAL. ONLY QUALIFIED AND/OR CERTIFIEDPERSONNEL SHOULD PERFORM INSTALLATION OF THIS FIXTURE AND ONLY THE ORIGINALRIGGING PARTS INCLUDED WITH THIS FIXTURE SHOULD BE USED FOR INSTALLATION. ANYMODIFICATIONS TO THE FIXTURE AND/OR CERTIFIED PERSONNEL SHOULD PERFORMINSTALLATION OF THIS FIXTURE AND/OR THE INCLUDED MOUNTING HARDWARE WILL VOIDTHE ORIGINAL MANUFACTURER’S WARRANTY AND INCREASE THE RISK OF DAMAGEAND/OR PERSONAL INJURY.• PROTECTION CLASS 1 - FIXTURE MUST BE PROPERLY GROUNDED• THERE ARE NO USER SERVICEABLE PARTS INSIDE THIS UNIT.• DO NOT ATTEMPT ANY REPAIRS YOURSELF; DOING SO WILL VOID YOURMANUFACTURER’S WARRANTY. DAMAGES RESULTING FROM MODIFICATIONS TO THISFIXTURE AND/OR THE DISREGARD OF SAFETY INSTRUCTIONS AND GUIDELINES IN THISMANUAL VOID THE MANUFACTURE’S WARRANTY AND ARE NOT SUBJECT TO ANYWARRANTY CLAIMS AND/OR REPAIRS.• DO NOT PLUG FIXTURE INTO A DIMMER PACK!• NEVER OPEN THIS FIXTURE WHILE IN USE!• UNPLUG POWER BEFORE SERVICING FIXTURE!• NEVER TOUCH FIXTURE DURING OPERATION, AS IT MAY BE HOT!• KEEP FLAMMABLE MATERIALS AWAY FROM FIXTURE!• NEVER LOOK DIRECTLY INTO THE LIGHT SOURCE!• RETINA INJURY RISK - MAY INDUCE BLINDNESS!• SENSITIVE PERSONS MAY SUFFER AN EPILEPTIC SHOCK!• INDOOR / DRY LOCATIONS USE ONLY!• DO NOT EXPOSE FIXTURE TO RAIN AND MOISTURE!• MINIMUM DISTANCE TO OBJECTS/SURFACES• MUST BE 6.6 FEET (2 METERS)• MAXIMUM TEMP OF EXTERNAL SURFACE 185° F (85°C)• MINIMUM DISTANCE OF INFLAMMABLE MATERIALS• FROM THE SURFACE 1.6 FEET (0.5 METER)'• DO NOT TOUCH the fixture housing during operation. Turn OFF the power and allow approximately60 minutes for the fixture to cool down before serving.• DO NOT shake fixture, avoid brute force when installing and/or operating fixture.• DO NOT operate fixture if the power cord is frayed, crimped, damaged and/or if any of the powercord connectors are damaged and do not insert into the fixture securely with ease. NEVER force apower cord connector into the fixture. If the power cord or any of its connectors are damaged,replace it immediately with a new one of similar power rating.• DO NOT block any air ventilation slots. All fan and air inlets must remain clean and never blocked.Allow approx. 6” (15cm) between fixture and other devices or a wall for proper cooling.• When installing fixture in a suspended environment, always use mounting hardware that is no less thanM10 x 25 mm, and always install fixture with an appropriately rated safety cable.• Always disconnect fixture from main power source before performing any type of service and/orcleaning procedure. Only handle the power cord by the plug end, never pull out the plug by tuggingthe wire portion of the cord.• During the initial operation of this fixture, a light smoke or smell may emit from the interior of thefixture. This is a normal process and is caused by excess paint in the interior of the casing burning offfrom the heat associated with the lamp and will decrease gradually over time.• Consistent operational breaks will ensure fixture will function properly for many years.• ONLY Use original packaging and materials to transport the fixture in for service.