ADJ GOBO PROJECTOR IR User Manual
Also see for GOBO PROJECTOR IR: User instructions
            |
9GOBO REPLACEMENTThe Gobo Projector IR features a replaceable gobo, which can be interchanged at any time in orderto customize your system. Follow the steps below to replace the gobo:1. Unscrew the two screws that hold the gobo housing in place. These screws are located on thebottom of the unit.2. Remove the gobo housing.3. Use a pair of needle nose pliers to remove the retaining ring that holds the gobo in place.4. Remove the gobo and replace with your desired replacement gobo. Reinsert the retainer ring,making sure that the ring rests firmly against the gobo.5. Slide the gobo assembly back into place, and tighten the two screws to secure the gobo housingin place.ADDING A COLOR GELThe Gobo Projector IR includes with 4 colored gels, which can be installed at any time in order to addbackground color to your gobo. Follow the steps below to install a color gel:1. Unscrew and remove the lens housing.2. Using a flat head screwdriver, carefully remove the retainer ring holding the lens into place.3. Remove the lens and insert your desired color gel. The gel should sit in place on the small ledgeinside the housing.4. With the gel in place, reinsert the lens. After the lens is inserted, reinsert the retainer ring so that itsits snugly against the lens. There should be no play between the lens and retainer ring.PHOTOMETRIC CHART1.0 2.0 3.0 4.000m( )5.013(LUX) 10130 2400 1030 560 3660.22 0.45 0.67 0.89 1.14 |
Related manuals for ADJ GOBO PROJECTOR IR
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine