ADJ Ricochet User Instructions

ADJ Products, LLC - www.adj.com - Ricochet Instruction Manual Page 11Sound Sense - In this mode you can adjust the soundsensitivity of the sound active mode.1. Press the MENU button until “Sound Sense” is displayed,press ENTER.2. Press the UP or DOWN buttons to adjust the sensitivity level.The sensitivity level can be adjusted between 0 (the lowest) and100 (most sensitive).3. Press ENTER to set you desired level.DMX Last State - This mode can be used as a precau-tion mode, that in case the DMX signal is lost, interrupted, orpower is lost, the operating mode chosen in the setup is therunning mode the fixture will go into when the DMX signal islost. You can also set this as the operating mode you wouldlike the unit to return to when power is applied.1. Press the MENU button until “DMX Last State” is displayed,and press ENTER. The current last state setting will be displayed.2. Use the UP or DOWN buttons to find a mode you would likethe unit to go into in case the DMX signal is lost.• Master/Slave - If the DMX signal is lost or power is applied,the unit will automatically go into Master Slave mode and run abuilt-in show.• Blackout - If the DMX signal is lost or interrupted, the unit willautomatically go into stand by mode.• Last State - If the DMX signal is lost the fixture will stay in thelast DMX setting. If power is applied and this mode is set, the unitwill automatically go into the last DMX set up.3. Press ENTER to confirm your desired set up.ADJ Products, LLC - www.adj.com - Ricochet Instruction Manual Page 10Ricochet System MenuBack Light - With this function the display back lightwill turn off after 2 minutes.1. Press the MENU button until “Back Light” is displayed, pressENTER.2. Either “ON” or “OFF” will now be displayed. Press the UP orDOWN buttons to select “ON” to keep the LED display on at alltimes, or “OFF” to allow the LED display to turn off after 2 min-utes. Press any button to turn on the LED display again.3. Press ENTER, and then press and hold the MENU button for atleast three seconds to confirm.Pan Invert - Pan Inversion1. Press the MENU button until “Pan Invert” is displayed, pressENTER. Either “Normal” or “Invert” will be displayed.2. To activate the Pan inversion press the UP or DOWN buttonsuntil “Invert” is displayed, press ENTER to confim. To deacti-vate Pan inversion, select “Normal” and press Enter.Tilt 1 Invert - Tilt Inversion1. Press the MENU button until “Tilt 1 Invert” is displayed,press ENTER. Either “Normal” or “Invert” will be displayed.2. To activate the Tilt inversion press the UP or DOWN buttonsuntil “Invert” is displayed, press ENTER to confim. To deacti-vate Tilt inversion, select “Normal” and press Enter.Auto Test - This function will run a self test program.1. Press the MENU button until “Auto Test” is displayed, pressENTER.2. The fixture will now run a self test. Press the MENU button toexit.Ricochet System Menu