ADJ Startec Series Mini Dekker LZR User Manual

ADJ Products, LLC - www.adj.com - Mini Dekker LZR User Manual Page 14SOSE - In this mode you can adjust the sound sensitivity.1. Press the MENU button until “SOSE” is displayed, and press ENTER.2. A number between 0-100 will be displayed. Press the UP or DOWN buttons to adjust the soundsensitivity. 0 is the least sensitive, and 100 is the most sensitive.3. When you have found your desired setting press ENTER to confirm.NODN - This setting defines the behavior of the fixture in the event that the DMX signal is lostor interrupted. It also determines the operating mode that the fixture defaults to when it is firstpowered up following a shut down.1. Press the MENU button until “NODN” is displayed, and either “PRGN”, “BLAC”, or “HOLD” willbe displayed beneath.2. Press ENTER and the bottom choice will begin to flash. Use the UP or DOWN buttons to choosean operating mode you would like the unit to start up in when power is applied or the DMX signalis lost.• HOLD - If the DMX signal is lost the fixture will stay in the last DMX setting. If power is ap-plied and this mode is set, the unit will automatically go into the last DMX set up.• PRGN (Primary Secondary) - If the DMX signal is lost or power is applied, the unit will auto-matically go into Primary Secondary mode and run a built-in show.• BLAC (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go intostand by mode.3. Press ENTER to confirm your desired set up.LED - With this function you can set the LED display to turn off after 10 seconds of inactivity.1. Press the MENU button until “LED” is displayed, and press ENTER.2. The display will show either “ON” or “OFF”. Press the UP or DOWN buttons to select “ON” tokeep the LED display on at all times, or “OFF” to switch to have the LED display switch off after10 sec-onds.STRO - This will activate strobing.1. Press the MENU button until “STRO” is displayed, and press ENTER.2. Use the UP or DOWN buttons to activate or deactivate strobing.TEST - This function will run a self test program.1. Press the MENU button until “TEST” is displayed, and press ENTER.2. The fixture will now run a self test.DISP - This function will reverse the display 180º.1. Press the MENU button until “DISP” is displayed, and press ENTER.2. To invert the display, press the UP or DOWN buttons. “DISP” shows the display in standard ori-entation, while “DSIP” inverts the display.3. Press ENTER to confirm. To make you LED display reappear again press any button.Mini Dekker LZR System Menu