183.a. Select Change Capture Plug-in andchoose Ulead Direct Show CapturePlug-in., Click OK.b. Select Device Control and set thecurrent device to TI 1394 DeviceControl or MS1394 depending uponwhich driver you are using (SeeConnecting Digital Camcorder sectionabove). Click OK.c. Click on Preferences to turn on/offthe user guide and the enable/disable“Click OK before capture” function. When learning to use VideoStudio you will want to have the User Guide turned on. TheUser Guide will give you a short overview of each mode as youmove from Capture to Storyboard to effects, etc. You can alsoaccess Video Studio HELP at any time by touching the “F1”button on your keyboard.Your Camcorder is a Plug & Play device:Your camcorder is a plug and play device. It is only present indevice manager if it is plugged in and turned on. Your camcordermust appear in Device Manager for Video Studio or any other soft-ware program to use the camcorder. The camcorder must alwaysbe “ON” before starting the Video Studio application. If you arenot able to Select Ulead Direct Show Capture Plug-in or changeDevice Control settings, then please check device manager againto be sure that your computer has detected your camcorder. Ifyour camcorder goes into “Sleep Mode” or is turned off, it will dis-appear from Device Manager. If your camcorder is not plugged into the PYRO card, your computer will not detect it.1. Run Video Studio.2. Before Starting a Project Click on the (G) Global Propertiesbutton. You will see a menu displayed like this. The BlackDot is highlighted next to the active video capture device.RUNNING VIDEO STUDIO for the First Time