ADT Safewatch Pro 3000 System Manual

Also see for Safewatch Pro 3000: User guide Installaton guide Programming guide

Contents

ADT Safewatch Pro 3000 System Manual Manual pdf 3 page image

Safewatch Pro 3000 System Manualhttps://alpha.adt.com/help/63[11/12/2018 9:41:21 PM]If you make a mistake while entering your security code, first stop and then press [*][*] to startover.There are four possible modes for arming your system:1. Instant Mode arms the entire perimeter when no one is expected to use an entry/exit door. Thealarm will sound immediately if any protected zone is opened, including designated entry/exit doors. Exitdelay is not possible in instant mode. To activate, press your [security code] + [7].2. Stay Mode arms the entire perimeter and an alarm will sound if any protected area or non-entry/exit ifopened. Stay mode triggers the exit delay; setting the stay mode does not arm the system immediatelybut rather after a designated amount of time (referred to as the exit delay). To activate, enter [securitycode] + [3]3. Night-Stay Mode arms the entire perimeter in addition to pre-selected interior sensors. In this mode,alarms will sound if interior zones are triggered (e.g., entering area in the middle of the night), thoughentry/exit is possible through designated areas. To activate, enter [security code] + [3] + [3].4. Away Mode arms the entire interior and exterior. As such, this mode is not ideal for those withpets/children roaming in and out of interior zones. Away mode triggers the exit delay; setting the awaymode does not arm the system immediately but rather after a designated amount of time (referred to asthe exit delay). You may reenter through the designated entry/exit door without causing an alarm, butyou must disarm the system within the entry delay period. To activate, enter [security code] + [2].DisarmingPLEASE NOTE: If your alarm is sounding upon return, DO NOT ENTER! CALL THE POLICE from a safelocation. If you return and find that the main sounder has shut itself off but the touchpad is beepingrapidly, TAKE CAUTION Your alarm was activated while you were out.Your security code + OFF is used to disarm the system, to silence the alarm and trouble sounds, and toclear any alarm memories. The touchpad will emit a single tone to confirm that the system has beendisarmed and/or silenced.To clear the memory of an alarm, press your security code + OFF key first, then enter your security code +OFF again to clear.Bypassing Protection ZonesZones (also called partitions) are areas that can be bypassed when arming the system. This could be idealfor those who want to arm all but one door/window.Bypassing Protection Zones