ADT Safewatch Pro 3000 System Manual

Also see for Safewatch Pro 3000: User guide Installaton guide Programming guide

Contents

ADT Safewatch Pro 3000 System Manual Manual pdf 6 page image

Safewatch Pro 3000 System Manualhttps://alpha.adt.com/help/63[11/12/2018 9:41:21 PM]Authority Level Mast/Prog code + [8] + [userno.] + [#][1] + authority level0 = standard user; 1 = arm only; 2 =guest; 3 = duress; 4= partitionprogrammerAccess Group Mast/Prog code + [8] + [userno.] + [#][2] + group (1-8)You can assign users to a group andthen set an access schedule that definesthe times this group can operate thesystem. The system will ignore theseusers outside of the scheduled times.User’s Partition Partition 1 =users 03-32 Partition 2 =users 33-49Master Code [8] + [user no.] +[#][3]+ partition(s) + [#] (toend)Use this command to assign thepartitions a specific user can access.Enter the numbers sequentially, thenend the entry with [#]. 0 = clearspartition 1 and partition 2 assignments; 1= partition 1; 2 = partition 2; 3 = commonpartitionsRF User Number Mast/Prog code + [8] + [userno.] + [#][4] + zone numberUse this command to assign a wirelessbutton device (keyfob) to this user. Forthe zone number, enter the numberassigned to a button on the keyfob thatwill be used for arming/disarming by thisuser.Pager On/Off Mast/Prog code + [8] + [userno.] + [#][5] + 0 or 1Program a user to receive a message totheir pager whenever this code is usedto arm/disarm. 1 = allow paging; 0= nopaging for this user.System TestingTesting Your SystemTesting allows for each protection point to be checked for proper operation. While the touchpad will beepevery 40 seconds during TEST mode, no alarm messages will be sent to the Customer Care Center. Werecommend testing the system once a month.To test the system:1. Disarm the system and close all protected areas. The READY light will appear.2. Enter your [security code] + [5] then [0] (walk).3. The external sounder should sound for 1 second. If it does not sound, call for service.4. Go through each fault zone individually. Open each door/window and listen for three beeps fromthe touchpad. The zone number or description should appear on the display and clear when the