ADT Security Manager 3000 User Manual
Also see for SafeWatch 3000: Installaton guideBATTERY REPLACEMENT INSTRUCTIONSProgramming guide
                                                        | |
– 28 –6HFXULW\&RGHV $XWKRULW\/HYHOV$ERXW6HFXULW\&RGHVYour system lets you assign up to 45 different security codes for use by other users.• Only the Master user or Partition Programmer can assign user codes to users.• Users are identified by 2-digit user numbers 03-49 and are pre-assigned toeither partition 1 or partition 2 (users 01-02 are reserved).• Only the Installer or Master can change the partitions to which a user is assigned.• In addition to a security code, each user is assigned various system attributes.• User codes can be used interchangeably within a partition when performingsystem functions (a system armed with one user's code can be disarmed byanother user's code), with the exception of the guest code described below.• User code programming involves these steps:- First, choose a user number from the set of users assigned to the partition inwhich the user will be operating, and assign a 4-digit security code.- Second, assign an authorty level to that user.- Lastly, assign other attributes as necessary (see attributes on the next page).$XWKRULW\/HYHO'HILQLWLRQVAuthority levels define the system functions a particular user can/cannot perform.Authority level categories are as follows:Level Title Explanationuser Master Can perform all system functions and assign codes in both02 partitions; can change its own code as follows:Master code + [8] + 02 + new master code + new master code again(0) Standard: Can only perform security functions in assigned partition.User Cannot perform other system functions.(1) Arm Only: Can only arm the system. Cannot disarm or do other functions.(2) Guest: Can arm the system in assigned partitions, but cannot disarmthe system unless the system was armed with this code. Thiscode is typically assigned to someone (such as a babysitter orcleaner) who has a need to arm/disarm the system only atcertain times. The user of this code should not use the “QuickArming” feature.(3) Duress Code: Intended for use when you are forced to disarm or arm thesystem under threat. When used, the system will act normally,but can silently notify the Customer Care Center of yoursituation, if that service has been provided.(4) Partition Can do everything a standard user can do, and can assignProgrammer user codes to users in their partition. |
Related manuals for ADT SafeWatch 3000
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine