ADTRAN 1203019L2 User Manual

Contents

61203019L1-1 NT1 ACE User Manual 7NT1 ACE User Manualpowered from the NT1, verify that the total power require-ment of the connected TE is less than 8.9 watts.To connect the NT1 ACE to the NT1 Power Supply, performthe following steps as illustrated in Figure 4.1. Connect the Power Supply to the NT1 ACE at thePOWER jack located on the NT1 ACE.2. Plug the Power Supply into the nearest wall outletsupplying 110 VAC, 60 HZ.3. On the NT1 ACE, verify that the POWER and ERRORindicators are illuminated. After approximately 15seconds, the READY indicator should flash at a 1 Hzrate. Should any of the indicators fail to operate asstated, see the section Troubleshooting on page 11.Figure 4. Power Supply ConnectionADTRANISDN PS2LOCALNETWORKPOWER1 0 0 - 1 2 0VA CREADYERRORPOWER