NETVANTA E1 W/ G.703 DROP NETWORK INTERFACE MODULE (NIM) P/N 1200878L1For more detailed documentation, visit us online at www.adtran.comQuick Start GuideQuick Start Guide, 61200878L1-13B, February 2004 ADTRAN Technical Support (+1-256-963-8716) © 2004 ADTRAN, All Rights ReservedSPECIFICATIONSE1/FE1InterfaceLine Rate: 2.048 Mbps +/- 50 PPMLine Code: AMI or HDB3Framing: FAS with optional CRC-4FE1 Line Rate: Timeslot, channelized(in multiples of 64 kbps)Receiver Sensitivity: -30 dBConnector: RJ-48CG.703InterfaceLine Interface: Per ITU-T G.703Receiver Sensitivity:-30 dBLine Rate: 2.048 Mbps, +/- 50 PPMCapacity: 1 to 31 timeslotsIf timeslot 16 signaling is used on the drop port, amaximum of 15 timeslots can be mapped to router(1-15 or 17-31).Line Code: AMI or HDB3Framing: FAS with Optional CRC-4Connector: RJ-48CClock Source Network, internal, and throughDiagnostics Test pattern generation and detection(QRSS, 511)Network loopbacksAlarm generation and detectionNetwork performance data (15 minutes and 24 hours)WAN-E1 G.703 DBUI NSTALLATION I NSTRUCTIONS1. Remove power from the unit.2. Slide the Network Interface Module (NIM) into theoption slot until the NIM is firmly seated against thefront of the chassis.3. Secure the pins at both edges of the NIM.4. Connect the cables to the associated device(s).5. Complete the installation of the base unit.6. Restore power to the unit.WAN-E1 NETWORK (RJ-48C) C ONNECTION PINOUTPin Name Description1 R1 Receive data from the network2 T1 Receive data from the network3 — Unused4 R Transmit data toward the network5 T Transmit data toward the network6-8 — UnusedG.703 (RJ-48C) CONNECTION PINOUTPin Name Description1 R Transmit data toward the DTE2 T Transmit data toward the DTE3 — Unused4 R1 Receive data from the DTE5 T1 Receive data from the DTE6-8 — Unused