ADTRAN TOTAL ACCESS 600R User Interface Manual

Also see for TOTAL ACCESS 600R: System manual Specifications System manual User Interface Guide

ADTRAN TOTAL ACCESS 600R User Interface Manual Manual pdf 54 page image

Page 54 © 2002, ADTRAN, Inc. 64200600L1#T-31ATotal Access 600R User Interface Guide (UIG)OUT TO PVCThe packets which transmit out this PVC from the Total Access 600R can be filtered in three ways:OUT EXCEPTIONSThis is a list of up to 32 filter entries. The setup is exactly the same as the F ILTER/IN E XCEPTIONSlist.Maintenance DLCIThe Total Access 600R can be configured from the WAN without having to preset a DLCI mapping orIP address. This value is the DLCI number used to open an IP session by the Total Access 600R. Any IPpacket arriving from the PVC is assumed to be for the Total Access 600R’s IP stack. The destinationaddress in the packet is assigned as the PVC’s local IP address. The source address is used to add a hostroute in the routing table. The default is 901, but any legal DLCI number can be used.BECN Timeout (msec)This value is expressed in milliseconds and represents the amount of time the Total Access 600R willstop transmitting over a PVC which received a packet with the BECN bit set. The default is 1.5 seconds.ROUTER >S TATUSUse the R OUTER/S TATUS menu to view and set the parameters shown in Figure 10. The R OUTER /STATUS screensgive the user useful information for debugging the current routes in the 600R.Figure 10. Router/Status MenuDISABLE (D EF ) Turns off packet output filtering. No outgoing packets to thisPVC are blocked.BLOCK A LL All outgoing packets to this PVC are blocked except as definedin the F ILTERS/O UT E XCEPTIONS list.F ORWARD ALL All outgoing packets to this PVC are not blocked except as de-fined in the F ILTERS/O UT E XCEPTIONS list.