ADTRAN TRACER 4106 Plan A System Manual

Also see for TRACER 4106: Quick reference guide Quick reference guide

FCC-Required Information TRACER 4106/4206 System Manual6 © 2003 ADTRAN, Inc. 612804206L2-1AFCC Output Power RestrictionsThe FCC does not require licensing to implement this device. License-free operation in the industrial,scientific, and medical band is documented in FCC Rules Part 15.247. It is the responsibility of theindividuals designing and implementing the radio system to assure compliance with any pertinent FCCRules and Regulations. This device must be professionally installed.Exposure to Radio Frequency FieldsThe TRACER 4106 is designed to operate at 2.4 GHz with 100 mW maximum transmit power. TheTRACER 4206 is designed to operate at 5.8 GHz with 100 mW maximum transmit power.This level of RF energy is below the Maximum Permissible Exposure (MPE) levels specified in FCC OET65:97-01. The installation of high gain antenna equipment in the system configuration may create theopportunity for exposure to levels higher than recommended for the general population at a distance lessthan 15 feet (4.6 meter) from the center of the antenna. The following precautions must be taken duringinstallation of this equipment:• The installed antenna must not be located in a manner that allows exposure of the general population tothe direct beam path of the antenna at a distance less than 15 feet (4.6 meters). Installation on towers,masts, or rooftops not accessible to the general population is recommended; or• Mount the antenna in a manner that prevents any personnel from entering the area within 15 feet (4.6meter) from the front of the antenna.• It is recommended that the installer place radio frequency hazard warnings signs on the barrier thatprevents access to the antenna.• Prior to installing the antenna to the TRACER 4106/4206 output, make sure the power is adjusted to thesettings specified in section 2 of this manual.• During antenna installation, be sure that power to the TRACER equipment is turned off in order toprevent any energy presence on the coaxial connector.• During installation and alignment of the antenna, do not stand in front of the antenna assembly.• During installation and alignment of the antenna, do not handle or touch the front of the antenna.These simple precautions must be taken to prevent general population and installation personnel fromexposure to RF energy in excess of specified MPE levels.Verify the antenna installation meets all regulations specified in the National ElectricCode (NEC) Article 810.