ADTRAN Total Access 900 Series Quick Start Manual

Also see for Total Access 900 Series: Quick configuration guide Hardware installation guide Quick configuration guide

ADTRAN Total Access 900 Series Quick Start Manual Manual pdf 1 page image

Quick StartGETTING S TARTEDThis Total Access unit ships with a statically assigned IP address of 10.10.10.1 and the ability to connect to aDynamic Host Control Protocol (DHCP) network and receive an IP address assignment from a DHCP server.When connecting to a DHCP network, this device supports Zero-Touch Provisioning, allowing the Total Accessunit to download and apply configuration parameters from a configuration management server.Regardless of the method you use to connect the Total Access unit to the network, there are two methodsavailable for configuration:■ Web-based graphical user interface (GUI)■ ADTRAN Operating System (AOS) command line interface (CLI)The GUI lets you configure the main unit settings and provides online guidance and explanations for eachsetting. However, using the AOS CLI may be necessary for more advanced configurations.ACCESS THE GUIYou may access the GUI from a web browser in one of two ways:Connect via the Static Address1. Connect the Total Access unit to your PC using the port labeled ETH 0/1 on the back of the unit.2. Set your PC to a fixed IP address of 10.10.10.2. To change your PC IP address, navigate to Computer> Control Panel > Network Connections > Local Area Connection > Properties > IP (TCP/IP) andselect Use this IP Address. Enter these parameters:IP Address: 10.10.10.2Subnet Mask: 255.255.255.0Default Gateway: 10.10.10.1You do not need to enter any DNS server information. After the information is entered, select Ok twice,and close the Network Connections dialog box. If you cannot change the PC’s IP address, you will needto change the unit’s IP address using the CLI. (Refer to “Manually Configuring the Unit’s IP Address” onpage 2.)3. Open a web browser and enter the unit’s IP address in your browser address line as follows:http://10.10.10.1. The default IP address is 10.10.10.1, but if you had to change the unit’s IP addressusing the CLI, enter that address in the browser line.4. The initial GUI screen appears.Connect via the DHCP Client Address1. Connect the Total Access unit to an existing network that supports DHCP using the port labeledETH 0/1 on the back of the device. The NetVanta unit will automatically request an IP address assign-ment from the DHCP server.2. Check the DHCP server and record the IP address assigned to the Total Access unit.3. Open a web browser on any network PC that can route to the IP address recorded in Step 2 and enterthe Total Access unit’s IP address.4. The initial GUI screen appears.ACCESS THE CLIAccess the AOS CLI via the console port or a Telnet or SSH session. To establish a console connection to theTotal Access via the port labeled CRAFT, you need the following items:■ PC with VT100 terminal emulation software■ Straight-through serial cable with a DB-9 (male) connector on one end and the appropriate interface foryour terminal or PC communication port on the other end.61213908F1-13A 1Total AccessTotal Access 900 Series(3rd Generation)September 202061213908F1-13AP/N: 1213908F14213916F14213924F1/F2

/ 4

Related manuals for ADTRAN Total Access 900 Series