ADURO H1 User Manual

Also see for H1: User manual User manual Update manual User manual User manual

Contents

ADURO H1 User Manual Manual pdf 54 page image

54Please ensure that all local rules and regulations are complied with, including CE marking of the exhaustconnector. Additionally, distance requirements to flammable material for the exhaust connector must berespected.2.3 Connection to a brick chimneyIf the stove is being connected to a brick chimney, the rear outlet should be used, or a curved flue pipe viathe top outlet. After measurement, a hole is made in the chimney in which the pipe sleeve is placed andfireplace mortar is used to seal it in place. The stove is placed in position and the flue pipe is put in place. Athin gasket is placed between the flue pipe and the pipe sleeve to seal the joints. The flue pipe shouldprotrude into the pipe sleeve, but must not block the opening in the chimney (see the illustration below).The Aduro H1 & H1 LUX can be connected to a chimney to which other heat sources are connected.2.4 Supply of combustion airAll wood burning stoves need constant supply of air to ensure aclean and efficient combustion. This is often a problem inmodern energy-efficient houses that are very tight. Therefore,the Aduro H1 & H1 LUX is equipped with external supply ofcombustion air, where the air to the combustion is supplied fromthe outside and directly into the wood burning stove. Air fromoutside can be provided through a channel, which is connectedto the connecting pipe under the combustion chamber. Theamount of air needed for combustion is 25 m3/h.The connecting pipe has an external diameter of 78 mm, towhich you need a pipe with a diameter of 80 mm. If the pipework is further than 1 m the pipe diameter must be increased to100 mm and a correspondingly larger wall valve must bechosen. In warm rooms the channel should be insulated with 30 mm mineral wool covered with a damp-proofcourse (plastic). It is important that the lead-in between the pipe and the wall (or floor) is sealed with jointingcompound. You can eventually use the complete Aduro fresh air kit.2.5 Aduro Hybrid AppIt is possible to control Aduro H1 & H1 LUX in three ways:1. Through the control panel on the stove.2. Through the app Aduro Hybrid 1 and the Wi-Fi module “Aduro” in the near of the stoveX