AEG 210621236-11052010 User Manual

Contents

Problem Possible cause SolutionWater flows on theground.The melting water outlet doesnot flow in the evaporative trayabove the compressor.Attach the melting water outletto the evaporative tray.There is too much frostand ice.Products are not wrapped prop-erly.Wrap the products better.The door is not closed correctly. Refer to "Closing the door".The Temperature regulator maybe set incorrectly.Set a higher temperature.The temperature in theappliance is too high.The door is not closed correctly. Refer to "Closing the door".The product temperature is toohigh.Let the product temperature de-crease to room temperature be-fore storage.Many products are stored atthe same time.Store less products at the sametime.The temperature in therefrigeration is too high.There is no cold air circulationin the appliance.Make sure that there is cold aircirculation in the appliance.The temperature in thefreezer is too high.Products are too near to eachother.Store products so that there iscold air circulation.The appliance does notoperate.The appliance is switched off. Switch on the appliance.The mains plug is not connec-ted to the mains socket correct-ly.Connect the mains plug to themains socket correctly.The appliance has no power.There is no voltage in the mainssocket.Connect a different electrical ap-pliance to the mains socket. Con-tact a qualified electrician.The lamp does not work. The lamp is in stand-by. Close and open the door.The lamp is defective. Refer to "Replacing the lamp".As much as the advice does not lead to result, call the nearest brand-mark service.Replacing the lamp1. Disconnect the appliance.2. Push the movable part to unhook thelamp cover (1).3. Remove the lamp cover (2).4. Replace the lamp with one of the samepower and specifically designed for do-mestic appliances only.5. Install the lamp cover.6. Connect the appliance.7. Open the door. Make sure that the lamp comes on.1 214 What to do if…