AEG BE5013001 User Manual

Also see for BE5013001: User manual

scratch the surface, which may result in shattering ofthe glass.• To remove the shelf supports first pull the front of theshelf support and then the rear end away from theside walls. Install the shelf supports in the oppositesequence.2. SAFETY INSTRUCTIONS2.1 InstallationWARNING!Only a qualified person must in-stall this appliance.• Remove all the packaging.• Do not install or use a damaged appli-ance.• Obey the installation instruction sup-plied with the appliance.• Always be careful when you move theappliance because it is heavy. Alwayswear safety gloves.• Do not pull the appliance by the han-dle.• Keep the minimum distance from theother appliances and units.• Make sure that the appliance is instal-led below and adjacent safe struc-tures.• The sides of the appliance must stayadjacent to appliances or to units withthe same height.Electrical connectionWARNING!Risk of fire and electrical shock.• All electrical connections should bemade by a qualified electrician.• The appliance must be earthed.• Make sure that the electrical informa-tion on the rating plate agrees withthe power supply. If not, contact anelectrician.• Always use a correctly installed shock-proof socket.• Do not use multi-plug adapters andextension cables.• Make sure not to cause damage to themains plug and to the mains cable.Contact the Service or an electrician tochange a damaged mains cable.• Do not let mains cables to come intouch with the appliance door, spe-cially when the door is hot.• The shock protection of live and insu-lated parts must be fastened in such away that it cannot be removed withouttools.• Connect the mains plug to the mainssocket only at the end of the installa-tion. Make sure that there is access tothe mains plug after the installation.• If the mains socket is loose, do notconnect the mains plug.• Do not pull the mains cable to discon-nect the appliance. Always pull themains plug.• Use only correct isolation devices: lineprotecting cut-outs, fuses (screw typefuses removed from the holder), earthleakage trips and contactors.• The electrical installation must have anisolation device which lets you discon-nect the appliance from the mains atall poles. The isolation device musthave a contact opening width of mini-mum 3 mm.2.2 UseWARNING!Risk of injury, burns or electricshock or explosion.4 www.aeg.com/au