The maximum capacity of the cavityembossment is 250 ml.Fill the cavity embossment with wateronly when the oven is cold.CAUTION!Do not refill the cavityembossment duringcooking or when theoven is hot.2. Set the function: .3. Turn the control knob to settemperature.4. Preheat the empty oven for 10minutes to create humidity.5. Put food in the oven.Refer to "Hints and tips" chapter.Do not open the oven door duringcooking.6. Turn the knob for the heatingfunctions to the off position to turnoff the oven.7. Remove water from the cavityembossment.WARNING!Make sure that the ovenis cold before youremove the remainingwater from the cavityembossment.7. CLOCK FUNCTIONS7.1 Clock functions tableClock function ApplicationTIME OF DAY To set, change or check the time of day.DURATION To set how long the appliance operates.END To set when the appliance deactivates.TIME DELAY To combine DURATION and END function.MINUTE MINDER To set countdown time. This function has no effect on theoperation of the appliance. You can set the MINUTE MIND-ER at any time, also when the appliance is off.7.2 Setting the time. Changingthe timeYou must set the time before youoperate the oven.The flashes when you connect theappliance to the electrical supply, whenthere was a power cut or when the timeris not set.Press the or to set the correcttime.After approximately five seconds, theflashing stops and the display shows thetime of day you set.To change the time of day pressagain and again until starts to flash.7.3 Setting the DURATION1. Set an oven function andtemperature.2. Press again and again untilstarts to flash.www.aeg.com10