5.6 Heat-up indicatorWhen you activate an oven function, thebars in the display come on one byone. The bars show that the oventemperature increases or decreases.6. CLOCK FUNCTIONS6.1 Clock functions tableClock function ApplicationTIME OF DAY To set, change or check the time of day. Refer to "Set-ting the time".MINUTE MINDER Use to set a countdown time (maximum 23 h 59 min).This function has no effect on the operation of the ap-pliance. You can set the MINUTE MINDER at any time,also if the appliance is off.DURATION To set how long the appliance operates. Use only whenan oven function is set.END To set when the appliance must deactivate. Use onlywhen an oven function is set. You can use Duration andEnd at the same time (time delay), if the appliance is tobe activate and deactivate automatically later.Press again and again toswitch between the clockfunctions.To confirm the settings ofthe clock functions, pressor wait 5 seconds for anautomatic confirmation.6.2 Setting the DURATION orEND1. Press again and again until thedisplay shows or .or flashes in the display.2. Press or to the set the valuesand press to confirm.For Duration first you set the minutesand then the hours, for End first youset the hours and then the minutes.An acoustic signal sounds for 2 minutesafter the time ends. or symboland time setting flash in the display. Theoven stops.3. Turn the knob for the oven functionsto the off position.4. Press any button or open the ovendoor to stop the acoustic signal.If you press when you setthe hours for DURATION, the appliance goes tosetting of the ENDfunction.6.3 Setting the MINUTEMINDER1. Press again and again until and"00" flash in the display.2. Press or to set the MINUTEMINDER.First you set the seconds, then theminutes and then the hours.At first, the time is calculated inminutes and seconds. When the timeyou set is longer than 60 minutes, thesymbol comes on in the display.www.aeg.com10