AEG BP500402W User Manual

12Install the shelf supports in the oppositesequence.10.3 PyrolysisCAUTION!Remove all accessories andremovable shelf supports.Do not start the Pyrolysis ifyou did not fully close theoven door. In some models,the display shows "C3"when this error occurs.WARNING!The appliance becomes veryhot. There is a risk of burns.CAUTION!If there are other appliancesinstalled in the samecabinet, do not use them atthe same time as thePyrolysis function. It cancause damage to theappliance.1. Remove the worst dirt manually.2. Clean the inner side of the door withhot water, so that the residues do notburn from the hot air.3. Set the Pyrolysis function. Refer to"Oven functions".4. When flashes, press or toset the necessary procedure:Option DescriptionP1 If the oven isnot very dirty.Time of theprocedure: 1h 30 min.P2 If you cannoteasily removethe dirt. Timeof the proce-dure: 2 h 30min.After 2 seconds the procedure starts.You can use the End function to delaythe start of the cleaning procedure.During the Pyrolysis the oven lamp is off.5. To change the default length of theprocedure (P1 or P2), press to set, and then press or to setthe length of the cleaning procedure.6. When the oven is at its settemperature, the door locks. Thedisplay shows the symbol and thebars of the heat indicator until thedoor unlocks.7. When Pyrolysis is completed, thedisplay shows the time of day. Theoven door stays locked.8. When the appliance is cool again, anacoustic signal sounds and the doorunlocks.10.4 Cleaning reminderTo remind you that the Pyrolysis isnecessary, PYR flashes in the display for10 seconds after each activation anddeactivation of the appliance.The cleaning remindergoes out:• after the end of thePyrolysis function.• if you press and atthe same time while PYRflashes in the display.ENGLISH 29