AEG Electrolux 16830 Instruction Booklet
                                                        | |
Contents
| 
Water inlet (cold water connection only)Connect the hose to a tap with a 3/4” thread.Installation should comply with local water authority and buildingregulations’ requirements.The inlet hose is provided with a water stopdevice, which protects against damagecaused by water leaks in the hose whichcould develop due to natural ageing of thehose. This fault is shown by a red sector inthe window “A”. Should this occur, turn thewater tap off and refer to your Service ForceCentre to replace the hose.Set the hose correctly by loosening the ringnut. After positioning the inlet hose, be sureto tighten the ring nut again to preventleaks.Do not connect to a hot water supply.Water drainageThis appliance is designed to be permanent-ly plumbed into your home's drainage sys-tem using one of the following methods.1. Into a drainage standpipe.Firstly form a hook in the end of the drainhose using the “U” piece” supplied.Place the drain hose intoyour standpipe, whichshould have an internaldiameter of approximately38mm thus ensuring thereis an air break between thedrain hose and standpipe.52Installation !"#$%&" |
Related manuals for AEG Electrolux 16830
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine