32 Care and cleaning8. Put the cap back on the emergencyemptying hose and place the latterback in its seat.9. Screw the pump fully in.10. Close the pump door.Warning!When the appliance is in use anddepending on the programme selectedthere can be hot water in the pump. Neverremove the pump cover during a washcycle, always wait until the appliance hasfinished the cycle, and is empty. Whenreplacing the cover, ensure it is securely retightened so as to stop leaks andyoung children being able to remove it.Water inlet filterIf you notice that the machine is taking longerto fill, check that the filter in the water inlethose is not blocked.1. Turn off the water tap.2. Unscrew the hose from the tap.3. Clean the filter in the hose with a stiffbrush.4. Screw the hose back onto the tap.Emergency emptying outIf the water is not discharged, proceed as follows to empty out the machine:1. pull out the plug from the power socket;2. close the water tap;3. if necessary, wait until the water has cooled down;4. open the the pump door;5. place a bowl on the floor and place the end of the emergency emptying hoseinto the bowl. Remove its cap. The water should drain by gravity into thebowl. Whe the bowl is full, put the cap back on the hose. Empty the bowl.Repeat the procedure until water stops flowing out;6. clean the pump if necessary as previously described;Ofrecido por www.electromanuales.com