AEG HC451500EB User Manual

Also see for HC451500EB: User manual

8.4 The installation of more than one applianceAdded parts:connection bar(s), heat re-sistant silicon, rubber shape, sealingstrap.Only use special a heat - resistantsilicon.580 mm520 mm490 mm360 mm+ - =20 mm 920 mm The worktop cut outDistance from the wall : minimum 50 mmDepth : 490 mmWidth : sum widths of all the appliancesto be built-in and subtract 20 mm (seealso "Overview of all appliance widths" )The installation of more than one appli-ance1. Put down the dimension of the work-top cut out and saw it out.2. Put the appliances one at time onsome soft surface, a blanket for ex-ample, with the bottom side up.3. Put the seal stripe around the loweredge of the appliance along theouter edge of the glass ceramic.4. Loosely screw the fixing plates intothe appropriate holes in the protec-tive casing.5. Put the first appliance in the work-top cut out. Put the connection barin the worktop cut out and push uphalf of the width against the appli-ance.6. Loosely turn in fixing plates frombelow on the worktop and on theconnection bar.7. Put the subsequent appliance in theworktop cut out . Make sure that thefront ends of the appliances are onthe same level.8. Tighten the fixing plate / retaininggrip screws.34 www.aeg.com