AEG HE634400XB User Manual

Also see for HE634400XB: User manual User manual

Contents

• Cookware made of cast iron, cast aluminium or with damaged bottoms can scratch theglass ceramic if you move them on the surface.• Do not let cookware boil dry to prevent the damage to cookware and glass ceramics.• Do not use the cooking zones with empty cookware or without cookware.• Do not cover the parts of the appliance with aluminium foil.• Do not cover the ventilation space of 5 mm between the worktop and front of the unitbelow it.WARNING!If there is a crack on the surface, disconnect power supply to prevent the electric shock.INSTALLATION INSTRUCTIONSBefore the installation , note down the serial number (Ser. Nr.) from the rating plate. Therating plate of the appliance is on its lower casing.HE634400XB 949 595 060 0058 GAD C6 AU 220-240 V 50-60-Hz7,4 kWInduction 7,4 kWAEGSafety instructionsWARNING!You must read these!Fully obey the laws, ordinances, directives and standards in force in the country where youuse the appliance (safety regulations, recycling regulations, electrical safety rules etc.)!Only a qualified electrician must install the appliance!Keep the minimum distances to other appliances and units!Install anti-shock protection, for example install the drawers only with a protective floordirectly below the appliance!Protect the cut surfaces of the worktop against moisture with a correct sealant!Seal the appliance to the work top with no space left with a correct sealant!Protect the bottom of the appliance from steam and moisture, e.g. from a dishwasher oroven!Do not install the appliance adjacent to doors and below windows! If not, hot cookware canbe hit off the hob when you open doors or windows.WARNING!Risk of injury from electrical current.The combination appliance is live.• Observe electrical safety rules.• Rated voltage of the combined appliances must match.• Fit plug and socket connections together properly.• Install correctly to give anti-shock protection.• Loose and incorrect plug and socket connections can make the terminal become too hot.• A qualified electrician must install the clamping connections correctly.Installation instructions 19