AEG HG654440 User Manual

Also see for HG654440: User manual User manual

Contents

LocationThe hob may be located in a kitchen, akitchen/diner or bed sitting room (with avolume greater than 20 m³), but not in abathroom or shower room.The minimum distance combustible ma-terial can be fitted above the hob in linewith the edges of the hob is 400 mm. If itis fitted below 400 mm a space of 50 mmmust be allowed from the edges of thehob.For appliances installed in the Republicof Ireland please refer to NSAI- Domes-tic Gas Installation I.S 813 Current Edi-tion Section 7- Permitted Locations ofAppliance.8.2 Gas ConnectionWARNING!Any gas installation must be car-ried out by a GAS SAFE REGIS-TER installer.Make sure that, once the hob is instal-led, it is easily accessible for the engi-neer in the event of a breakdown.The manufacturer will not accept liability,should the above instructions or any ofthe other safety instructions incorpora-ted in this instruction booklet be ignor-ed.On the end of the shaft, which includesthe G 1/2" threaded elbow, adjustmentis fixed so that the washer is fitted be-tween the components as shown in thediagram. Screw the parts together with-out using excessive force.A B CA) End of shaft with nutB) WasherC) ElbowConnection to the gas supply should bewith either rigid or semi-rigid pipe, i.e.steel or copper.The connection should be suitable forconnecting to R 1/2 (1/2 BSP malethread).When the final connection has beenmade, it is essential that a thorough leaktest is carried out on the hob and instal-lation.Make sure that the main connectionpipe does not exert any strain on thehob.If you use flexible metal pipes make surethat they agree to ISO 10380 and ISO10807 standards. Be careful they do notcome in touch with mobile parts or theyare not squeezed. Also be careful whenthe hob is put together with an oven.It is important to install the elbowcorrectly, with the shoulder onthe end of the thread, fitted tothe hob connecting pipe.Failure to ensure the correct as-sembly will cause leakage of gas.Make sure that the gas supplypressure of the appliance obeysthe recommended values.Rigid connection:Carry out connection by using metal rig-id pipes (copper with mechanical end).8.3 Injectors replacement1. Remove the pan supports.2. Remove the caps and crowns of theburner.3. With a socket spanner 7 remove theinjectors and replace them with theones which are necessary for thetype of gas you use (see table in"Technical Information" chapter).4. Assemble the parts, follow the sameprocedure backwards.5. Replace the rating plate (it is nearthe gas supply pipe) with the one forthe new type of gas supply. You canfind this plate in the package sup-plied with the appliance.If the supply gas pressure is changeableor different from the necessary pressure,you must fit an applicable pressure ad-juster on the gas supply pipe.12 www.aeg.com