7.3 Labels supplied with theaccessories bagStick the adhesive labels as indicatedbelow:MOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NO.03 ITMADE IN ITALYTYPEIP200049A B CA. Stick it on Guarantee Card and sendthis part (if applicable).B. Stick it on Guarantee Card and keepthis part (if applicable).C. Stick it on instruction booklet.8. INSTALLATIONWARNING!Refer to Safety chapters.8.1 Before the installationBefore you install the hob, write downthe information bellow from the ratingplate. The rating plate is on the bottomof the hob.Model .......................................PNC .........................................Serial number ...........................8.2 Important safetyrequirementsThis hob must be installed in accordancewith the Gas Safety (Installation and Use)Regulations (Current Edition) and the IEEWiring Regulations (Current Edition).For appliances installed in the Republicof Ireland please refer to NSAI- DomesticGas Installation I.S. 813 Current Editionsand the ETCI Rules for ElectricalInstallations.Provision for ventilationDetailed recommendations arecontained in the following BritishStandards Codes Of Practice: B.S. 6172/B.S. 5440, Par. 2 and B.S. 6891 CurrentEditions.The hob should not be installed in a bedsitting room with a volume of less than20 m³. If it is installed in a room ofvolume less than 5 m³ an air vent ofeffective area of 100 cm² is required. If itis installed in a room of volume between5 m³ and 10 m³ an air vent of effectivearea of 50 cm² is required, while if thevolume exceeds 11 m³ no air vent isrequired.www.aeg.com12