AEG HK6542H0XB User Manual

Problem Possible cause Remedycomes on. There is an error in the hobbecause a cookware boilsdry. Automatic Switch Offand the overheating protec-tion for the zones operate.Deactivate the hob. Removethe hot cookware. After ap-proximately 30 seconds, acti-vate the zone again. If thecookware was the problem,the error message goes out.Residual heat indicator canstay on. Let the cookwarebecome sufficiently cool.Check if your cookware iscompatible with the hob.Refer to “Hints and tips”chapter.7.2 If you cannot find asolution...If you cannot find a solution to theproblem yourself, contact your dealer oran Authorised Service Centre. Give thedata from the rating plate. Give alsothree digit letter code for the glassceramic (it is in the corner of the glasssurface) and an error message thatcomes on. Make sure, you operated thehob correctly. If not the servicing by aservice technician or dealer will not befree of charge, also during the warrantyperiod. The instructions about theService Centre and conditions ofguarantee are in the guarantee booklet.8. INSTALLATIONWARNING!Refer to Safety chapters.8.1 Before the installationBefore you install the hob, write downthe information bellow from the ratingplate. The rating plate is on the bottomof the hob.Serial number ...........................8.2 Built-in hobsOnly use the built-in hobs after youassemble the hob into correct built-inunits and work surfaces that align to thestandards.8.3 Connection cable• The hob is supplied with a connectioncable.• To replace the damaged mains cableuse the following (or higher) mainscable type: H05BB-F Tmax 90°C.Speak to your local Service Centre.ENGLISH 17