AEG ITE42600KB User Manual

Also see for ITE42600KB: User manual

3. INSTALLATIONWARNING!Refer to Safety chapters.3.1 Before the installationBefore you install the appliance, writedown the information bellow from therating plate. The rating plate is on thebottom of the appliance.Serial number ...........................3.2 Built-in applianceOnly use the built-in appliances after youassemble the appliance into correctbuilt-in units and work surfaces that alignto the standards.3.3 Connection cable• The appliance is supplied with aconnection cable.• To replace the damaged mains cableuse the following (or higher) mainscable type: H05V2V2-F T min 90°C.Speak to your local Service Centre.3.4 Attaching the seal - On-topinstallation1. Clean the worktop around the cutout area.2. Attach the supplied 2x6mm sealstripe to the lower edge of theappliance, along the outer edge ofthe glass ceramic. Do not stretch it.Make sure that the ends of the sealstripe are located in the middle ofone side of the appliance.3. Add some millimetres to the lengthwhen you cut the seal stripe.4. Join the two ends of the seal stripetogether.3.5 Assemblymin.50mmmin.500mmmin.2mm360 520ENGLISH 7