12.4 Steam generation systemCAUTION!Dry the steam generatorafter each use. Remove thewater with the sponge.Remove the limescale withwater and vinegar.CAUTION!Chemical de-scaling agentscan cause damage to theenamel. Follow theinstructions of themanufacturer.1. To clean the water drawer and thesteam generator, put the water andvinegar mixture (approximately 250ml) through the water drawer into thesteam generator. Wait forapproximately 10 minutes.2. Remove the water and vinegar withthe sponge.3. Put clean water (100 - 200 ml) into thewater drawer to flush the steamgeneration system.4. Remove the water from the steamgenerator with the sponge and rub itdry.5. Keep the door open to let theappliance dry fully.12.5 Removing the oven doorRemove the door to clean the inner sideof the appliance more easily.WARNING!Be careful when you removethe door from the appliance.The door is heavy.1. Open the door fully.2. Fully release the clamping levers onthe hinges.3423. Hold the door on the two sides andclose it approximately 3/4 of the way.4. Pull the door away from theappliance.5. Put the door with the outer sidedown on a soft cloth on a stablesurface. This is to prevent scratches.12.6 Installing the oven doorWARNING!Be careful when you installthe door. The door is heavy.1. Hold the door on the two sides at anangle of approximately 60°.34460º52. At the same time push the doorhinges as far as they can go into thetwo recesses at the bottom of theappliance on the left and the right.3. Lift the door up until you are at thepoint of resistance and then open itas far as possible.4. Fully lock the clamping levers on thehinges.5. Close the door of the appliance.12.7 Replacing the lampPut a cloth on the bottom of the interiorof the appliance. It prevents damage tothe lamp glass cover and the cavity.www.aeg.com34