2 www.aeg.comInstallationWARNING!install this appliance.• Remove all the packaging.• Do not install or use a damagedappliance.• Obey the installation instructionsupplied with the appliance.• Always be careful when you move theappliance because it is heavy. Alwayswear safety gloves.• Make sure the air can circulatearound the appliance.• Wait at least 4 hours beforeconnecting the appliance to the powerback in the compressor.• Do not install the appliance close toradiators or cookers, oven or hobs.• The rear of the appliance must standagainst the wall.• Do not install the appliance wherethere is direct sunlight.• Do not install this appliance in areasthat are too humid or too colds, suchas the construction appendices,garages or wine cellars.• When you move the appliance, lift itby the front edge to avoid scratching.Electrical connectionWARNING!• The appliance must be earthed.• All electrical connections should be• Make sure that the electrical informa-tion on the rating plate agrees withthe power supply. If not, contact anelectrician.• Always use a correctly installedshockproof socket.• Do not use multi-plug adapters andextension cables.• Make sure not to cause damage tothe electrical components (e.g. mainsplug, mains cable, compressor). Con-tact the Service or an electrician tochange the electrical components.• The mains cable must stay below thelevel of the mains plug.• Connect the mains plug to the mainssocket only at the end of the installa-tion. Make sure that there is accessto the mains plug after the installation.• Do not pull the mains cable to discon-nect the appliance. Always pull themains plug.UseWARNING!Risk of injury, burns, electricalSAFETY INSTRUCTIONS• If the supply cord is damaged, it must be replaced by the manufac-a hazard.• If the appliance is equipped with an Ice maker or a water dispenser,.• If the appliance requires a water connection, connect it to potablewater supply only.• The inlet water pressure (minimum and maximum)must be between0,15 MPa and 0,85 MPa